Nissan Altima (L32) 2007-2012 Service Manual ≻ Power window control system lh&rh front anti-pinch-sedan ≻ Symptom diagnosis ≻ Rear rh side power window alone does not operate

Nissan Altima (L32) 2007-2012 Service Manual: Rear rh side power window alone does not operate

Diagnosis Procedure

1. CHECK REAR POWER WINDOW SWITCH RH

Check rear power winodw switch RH.

Refer to PWC-310, "REAR POWER WINDOW SWITCH : Component Function Check".

Is the inspection result normal? YES >> GO TO 2

NO >> Repair or replace the malfunctioning parts.

2. CHECK REAR POWER WINDOW MOTOR RH

Check rear power window motor RH.

Refer to PWC-318, "REAR RH : Component Function Check".

Is the inspection result normal? YES >> Inspection end.

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

Rear lh side power window alone does not operate

Diagnosis Procedure 1. CHECK REAR POWER WINDOW SWITCH LH Check rear power window switch LH. Refer to PWC-310, "REAR POWER WINDOW SWITCH : Component Function Check". Is th e inspectio ...

Anti-pinch system does not operate normally (driver side)

Diagnosis Procedure 1. PERFORM INITIALIZATION PROCEDURE Perform initialization procedure. Refer to PWC-295, "ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement&quo ...

Other materials:

Programming HomeLink for Canadian customers and gate openers
Canadian radio-frequency laws require transmitter signals to "time-out" (or quit) after several seconds of transmission - which may not be long enough for HomeLink to pick up the signal during training. Similar to this Canadian law, some U.S. gate operators are designed to "timeout" in the same mann ...

System temporarily unavailable
For vehicles with the 7 inch (18 cm) display When radar blockage is detected, the system will be deactivated automatically. The "Unavailable: Side Radar Obstruction" warning message will appear in the vehicle information display. The systems are not available until the conditions no longer exist. ...

System maintenance
The two radar sensors 1 for the BSW and RCTA systems are located near the rear bumper. Always keep the area near the radar sensors clean. The radar sensors may be blocked by temporary ambient conditions such as splashing water, mist or fog. The blocked condition may also be caused by objects such ...