Nissan Altima (L32) 2007-2012 Service Manual ≻ Power window control system lh only anti-pinch-coupe ≻ Symptom diagnosis ≻ Passenger side power window alone does not operate

Nissan Altima (L32) 2007-2012 Service Manual: Passenger side power window alone does not operate

Diagnosis Procedure

1. CHECK POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH RH

Check power window and door lock/unlock switch RH.

Refer to PWC-22, "PASSENGER SIDE : Component Function Check".

Is the inspection result normal? YES >> GO TO 2

NO >> Repair or replace the malfunctioning parts.

2. CHECK FRONT POWER WINDOW MOTOR RH CIRCUIT

Check power window motor RH circuit.

Refer to PWC-27, "PASSENGER SIDE : Component Function Check".

Is the inspection result normal? YES >> Inspection End.

NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".

Driver side power window alone does not operate

Diagnosis Procedure 1. CHECK POWER WINDOW MOTOR LH Check power window motor LH. Refer to PWC-25, "DRIVER SIDE : Component Function Check". Is the inspection result normal? YES >& ...

Anti-pinch system does not operate normally (driver side)

Diagnosis Procedure 1. PERFORM INITIALIZATION PROCEDURE Perform initialization procedure. Refer to PWC-21, "POWER WINDOW MAIN SWITCH : Special Repair Requirement". Is the inspection ...

Other materials:

Heater operation
Heating This mode is used to direct heated air to the foot outlets. Some air also flows from the defrost outlets and the side vent outlets. 1. Press thebutton to the off position for normal heating. 2. Press theair flow control button. 3. Turn thefan speed control dial to the desired position. ...

Heated seat switches (if so equipped)
WARNING Do not use or allow occupants to use the seat heater if you or the occupants cannot monitor elevated seat temperatures or have an inability to feel pain in body parts that contact the seat. Use of the seat heater by such people could result in serious injury. CAUTION The battery could run ...

Starting the engine
1. Apply the parking brake. 2. Move the shift lever to P (Park) or N (Neutral). P (Park) is recommended. The starter is designed not to operate if the shift lever is in any of the driving positions. 3. Push the ignition switch to the ON position. Depress the brake pedal and push the ignition swi ...