Nissan Altima (L32) 2007-2012 Service Manual: Ignition timing
Description
This describes how to check the ignition timing. For the actual procedure,
follow the instructions in “BASIC
INSPECTION”.
Special Repair Requirement
1.CHECK IGNITION TIMING
1. Attach timing light to loop wires (2) as shown.
- Intake manifold collector (1)
- Timing light pick-up lead (3)
2. Check ignition timing.
>> INSPECTION END
Description
This describes how to check the idle speed. For the actual procedure, follow
the instructions in “BASIC
INSPECTION”.
Special Repair Requirement
1.CHECK IDLE SPEED
Check idle ...
Description
VIN Registration is an operation to register VIN in ECM. It must be performed
each time ECM is replaced.
NOTE:
Accurate VIN which is registered in ECM may be required for Ins ...
Other materials: I-LI system limitations
WARNING
Listed below are the system limitations
for the I-LI system. Failure to follow the
warnings and instructions for proper
use of the I-LI system could result in
serious injury or death.
The I-LI system may activate if you
change lanes without first activating
your turn signal or, for examp ...
General maintenance
During the normal day-to-day operation of
the vehicle, general maintenance should
be performed regularly as prescribed in
this section. If you detect any unusual
sounds, vibrations or smells, be sure to
check for the cause or have it checked
promptly. In addition, it is recommended
that you visit a ...
Rapid air pressure loss
Rapid air pressure loss or a "blow-out" can
occur if the tire is punctured or is damaged
due to hitting a curb or pothole. Rapid air
pressure loss can also be caused by driving
on under-inflated tires.
Rapid air pressure loss can affect the handling
and stability of the vehicle, especially
at highw ...