Nissan Altima (L32) 2007-2012 Service Manual ≻ Audio, visual & navigation system bose audio without navigation ≻ Component diagnosis ≻ Sound signal circuit (sedan)

Nissan Altima (L32) 2007-2012 Service Manual: Sound signal circuit (sedan)

SATELLITE RADIO TUNER

Description

Left and right channel audio signals are supplied from the satellite radio tuner to the audio unit through the sound signal circuits.

Diagnosis Procedure

LEFT CHANNEL

1.CHECK HARNESS

1. Turn ignition switch OFF.

2. Disconnect satellite radio tuner (factory installed) connector B123 and audio unit connector M45.

3. Check continuity between satellite radio tuner (factory installed) connector B123 (A) and audio unit connector M45 (B).

4. Check continuity between satellite radio tuner (factory installed) connector B123 (A) and ground.

Are continuity results as specified? YES >> GO TO 2

NO >> Repair harness or connector.

2.CHECK LEFT CHANNEL AUDIO SIGNAL

1. Connect satellite radio tuner (factory installed) and audio unit.

2. Turn ignition switch ON.

3. Check signal between satellite radio tuner (factory installed) connector B123 terminals 21 and 22 with CONSULT-III or oscilloscope.

Are voltage readings as specified? YES >> Replace audio unit. Refer to AV-215, "Removal and Installation".

NO >> Replace satellite radio tuner. Refer to AV-223, "Removal and Installation - Sedan".

RIGHT CHANNEL

1.CHECK HARNESS

1. Turn ignition switch OFF.

2. Disconnect satellite radio tuner (factory installed) connector B123 and audio unit connector M45.

3. Check continuity between satellite radio tuner (factory installed) connector B123 (A) and audio unit connector M45 (B).

4. Check continuity between satellite radio tuner (factory installed) connector B123 (A) and ground.

Are continuity results as specified? YES >> GO TO 2

NO >> Repair harness or connector.

2.CHECK RIGHT CHANNEL AUDIO SIGNAL

1. Connect satellite radio tuner (factory installed) and audio unit.

2. Turn ignition switch ON.

3. Check signal between satellite radio tuner (factory installed) connector B123 terminals 23 and 24 with CONSULT-III or oscilloscope.

Are voltage readings as specified? YES >> Replace audio unit. Refer to AV-215, "Removal and Installation".

NO >> Replace satellite radio tuner. Refer to AV-223, "Removal and Installation - Sedan".

Sound signal circuit (coupe)

SATELLITE RADIO TUNER Description Left and right channel audio signals are supplied from the satellite radio tuner to the audio unit through the sound signal circuits. Diagnosis Procedure LEF ...

Microphone signal circuit (coupe)

Description Voice signals are transmitted from the microphone to the Bluetooth control unit using the microphone signal circuits. Diagnosis Procedure 1.CHECK HARNESS BETWEEN BLUETOOTH CONTROL U ...

Other materials:

Cleaning interior
Occasionally remove loose dust from the interior trim, plastic parts and seats using a vacuum cleaner or soft bristled brush. Wipe the vinyl and leather (if so equipped) surfaces with a clean, soft cloth dampened in mild soap solution, then wipe clean with a dry, soft cloth. Regular care and cleani ...

LDW system operation
For vehicles with the 7 inch (18 cm) display The LDW system provides a lane departure warning function when the vehicle is driven at speeds of approximately 37 mph (60 km/h) and above and the lane markings are clear. When the vehicle approaches either the left or the right side of the traveling lan ...

Corrosion protection
Most common factors contributing to vehicle corrosion Most vehicle corrosion is caused by: The accumulation of moisture-retaining dirt and debris in body panel sections, cavities, and other areas. Damage to paint and other protective coatings caused by gravel and stone chips or minor traffic ...