Nissan Altima manuals

Nissan Altima (L34) 2019-2024 Owners Manual: Remote Engine Start

Nissan Altima L34. Remote Engine Start

The button will be on the NISSAN Intelligent Key if the vehicle has Remote Engine Start. This feature allows the engine to start from outside the vehicle.

The following features may be affected when Remote Engine Start is used:

Laws in some local communities may restrict or prohibit the use of Remote Engine Start, or the amount of time a parked vehicle engine may idle. For example, some laws require a person using Remote Engine Start to have the vehicle in view or may restrict idling time except in freezing temperatures.

Check local regulations for any requirements.

Other conditions may affect the function of the Remote Engine Start feature. For additional information, see "Conditions the Remote Engine Start will not work".

Other conditions can affect the performance of the Intelligent Key transmitter.

For additional information, see "NISSAN Intelligent Key".

Remote Engine Start operating range

WARNING

CAUTION

When the Intelligent Key battery is discharged or other strong radio wave sources are present near the operating location, the Intelligent Key operating range becomes narrower, and the Intelligent Key may not function properly.

The Remote Engine Start function can only be used when the Intelligent Key is within the specified operating range from the vehicle.

The Remote Engine Start operating range is approximately 197 ft (60 m) from the vehicle.

Remote starting the vehicle

To use the Remote Engine Start feature to start the engine perform the following:

1. Aim the Intelligent Key at the vehicle.

2. Press the button to lock all doors.

3. Within 5 seconds press and hold the button until the turn signal lights flash and the tail lamps turn on. If the vehicle is not within view press and hold the button for at least 2 seconds.

The following events will occur when the engine starts:

Depress and hold the brake then push the push-button ignition switch to the ON position before driving. For additional information, see "Driving the vehicle".

Extending engine run time

The Remote Engine Start feature can be extended one time by performing the steps listed in "Remote starting the vehicle" in this section. Run time will be calculated as follows:

A maximum of two Remote Engine Starts, or a single Remote Engine Start with an extension, are allowed between ignition cycles. The ignition switch must be cycled to the ON position and then back to the OFF position before the Remote Engine Start procedure can be used again.

Canceling a Remote Engine Start

To cancel a Remote Engine Start, perform one of the following:

Conditions the Remote Engine Start will not work

The Remote Engine Start will not operate if any of the following conditions are present:

The Remote Engine Start may display a warning or indicator in the vehicle information display. For additional information, see "Vehicle information display - 5 inch (13 cm) Type A (if so equipped)" or "Vehicle information display - 7 inch (18 cm) Type B (if so equipped)".

How to use the remote keyless entry function

(remote engine start) button (lock) button (unlock) button (trunk) button (panic) button The remote keyless entry function can operate all door locks using the remote keyless fu ...

Hood

Pull the hood lock release handle 1 located below the driver's side instrument panel; the hood springs up slightly. To open the hood, push the lever 2 underneath the front of the hood upwards ...