Nissan Altima (L32) 2007-2012 Service Manual ≻ Audio, visual & navigation system bose audio without navigation ≻ Component diagnosis ≻ Rear tweeter (coupe)

Nissan Altima (L32) 2007-2012 Service Manual: Rear tweeter (coupe)

Description

The audio unit sends audio signals to the BOSE speaker amp. The BOSE speaker amp. amplifies the audio signals before sending them to the rear tweeters using the audio signal circuits.

Diagnosis Procedure

1.HARNESS CHECK

1. Disconnect BOSE speaker amp. connectors B121, B122 and suspect tweeter connector.

2. Check continuity between BOSE speaker amp. harness connectors B121 (A) and B122 (B) and suspect tweeter harness connector (C).

3. Check continuity between BOSE speaker amp. harness connectors B121 (A) and B122 (B) and ground.

Are the continuity test results as specified? YES >> GO TO 2

NO >> • Check connector housings for disconnected or loose terminals.

• Repair harness or connector.

2.REAR DOOR SPEAKER SIGNAL CHECK

1. Connect BOSE speaker amp. connectors and suspect tweeter connector.

2. Turn ignition switch to ACC.

3. Push “POWER” switch.

4. Check the signal between BOSE speaker amp. harness connectors B121 (A) and B122 (B) terminals with CONSULT-III or oscilloscope.

Are audio signal voltage readings as specified? YES >> Replace suspect tweeter. Refer to AV-221, "Removal and Installation - Coupe".

NO >> GO TO 3

3.HARNESS CHECK

1. Disconnect audio unit connector M43 and BOSE speaker amp.

connector B121.

2. Check continuity between audio unit harness connector M43 (A) and BOSE speaker amp. harness connector B121 (B).

3. Check continuity between audio unit harness connector M43 (A) and ground.

Are the continuity test results as specified? YES >> GO TO 4

NO >> • Check connector housings for disconnected or loose terminals.

• Repair harness or connector.

4.REAR DOOR SPEAKER SIGNAL CHECK

1. Connect audio unit connector M43 and BOSE speaker amp.

connector B121.

2. Turn ignition switch to ACC.

3. Push “POWER” switch.

4. Check the signal between audio unit harness connector M43 terminals with CONSULT-III or oscilloscope.

Is the audio signal voltage reading as specified? YES >> Replace BOSE speaker amp. Refer to AV-216, "Removal and Installation - Coupe".

NO >> Replace audio unit. Refer to AV-215, "Removal and Installation".

Center speaker

Description The audio unit sends audio signals to the BOSE speaker amp. The BOSE speaker amp. amplifies the audio signals before sending them to the center speaker using the audio signal circui ...

Rear door speaker (sedan)

Description The audio unit sends audio signals to the BOSE speaker amp. The BOSE speaker amp. amplifies the audio signals before sending them to the rear door speakers using the audio signal ci ...

Other materials:

Jacking up vehicle and replacing the damaged tire (AWD models)
WARNING For AWD vehicles - the TEMPORARY USE ONLY spare tire must be installed to the rear wheels only. If a front tire is punctured, install the original rear tire onto the front wheel, then install the TEMPORARY USE ONLY spare tire on the rear. Failure to do so could cause overheating to the AWD ...

Operating ProPILOT Assist
Push the ProPILOT Assist switch A. This turns on the ProPILOT Assist system. A screen is displayed for a period of time that indicates the status of the driving aid functions. AEB with Pedestrian Detection, LDW, and BSW are enabled when the specified driving aid is shaded. I-LI is ...

Automatic brake hold (if so equipped)
The automatic brake hold function maintains the braking force without the driver having to depress the brake pedal when the vehicle is stopped at a traffic light or intersection. As soon as the driver depresses the accelerator pedal again, the automatic brake hold function is deactivated and the bra ...