Nissan Altima (L32) 2007-2012 Service Manual: None of the power windows can be
operated using any switch
Diagnosis Procedure
1. CHECK BCM POWER SUPPLY AND GROUND CIRCUIT
Check BCM power supply and ground circuit.
Refer to BCS-42, "Diagnosis Procedure".
Is the inspection result normal?
YES >> GO TO 2
NO >> Repair or replace the malfunctioning parts.
2. CHECK MAIN POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH POWER SUPPLY AND
GROUND CIRCUIT
Check main power window and door lock/unlock switch power supply and ground
circuit.
Refer to PWC-103, "POWER WINDOW MAIN SWITCH : Component Function Check".
Is the inspection result normal?
YES >> GO TO 3
NO >> Repair or replace the malfunctioning parts.
3. CHECK MAIN POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH
Check main power window and door lock/unlock switch.
Refer to PWC-103, "POWER WINDOW MAIN SWITCH : Component Function Check".
Is the inspection result normal?
YES >> Inspection end.
NO >> Check intermittent incident. Refer to GI-42, "Intermittent Incident".
Diagnosis Procedure
1. CHECK FRONT POWER WINDOW MOTOR LH
Check front power window motor LH.
Refer to PWC-114, "DRIVER SIDE : Component Function Check".
Is the inspection result norma ...
Other materials: Intelligent Driver Alertness (I-DA)
WARNING
Failure to follow the warnings and instructions
for proper use of the I-DA
system could result in serious injury or
death.
The I-DA system is only a warning to
inform the driver of a potential lack
of driver attention or drowsiness. It
will not steer the vehicle or prevent
loss of cont ...
Steering Assist
WARNING
Failure to follow the warnings and instructions
for proper use of the Steering
Assist could result in serious injury
or death.
The Steering Assist is not a replacement
for proper driving procedures
and is not designed to correct careless,
inattentive or absent-minded
driving. The Steer ...
Difference between predicted and
actual distances
The displayed guidelines and their locations
on the ground are for approximate
reference only. Objects on uphill or downhill
surfaces or projecting objects will be actually
located at distances different from
those displayed in the monitor relative to
the guidelines (refer to illustrations). When
in ...