Nissan Altima (L32) 2007-2012 Service Manual: DTC U1000 can communication
DTC Logic
DTC DETECTION LOGIC
Diagnosis Procedure
Symptom: Displays “CAN COMM CIRC [U1000]” as a self-diagnosis result of
combination meter.
1.CHECK CAN COMMUNICATION
Select “SELF-DIAG RESULTS” mode for “METER/M&A” with CONSULT-III.
>> Go to “LAN system”. Refer to LAN-10, "Condition of Error Detection".
Description
The ABS actuator and electric unit (control unit) provides a vehicle speed
signal to the combination meter via
CAN communication lines.
DTC Logic
Diagnosis Procedure
Symptom: Disp ...
Other materials: Fuel gauge
The gauge indicates the approximate fuel
level in the tank.
The gauge may move slightly during braking,
turning, acceleration, or going up or
down hills.
The gauge needle returns to 0 (Empty) after
the ignition switch is placed in the OFF
position.
The low fuel warning message shows in
the vehic ...
Seat belt extenders
If, because of body size or driving position, it
is not possible to properly fit the lap/
shoulder belt and fasten it, an extender
that is compatible with the installed seat
belts is available for purchase. The extender
adds approximately 8 in (200 mm)
of length and may be used for either the
driver ...
ICC system limitations
WARNING
Listed below are the system limitations
for the ICC system. Failure to operate
the vehicle in accordance with these
system limitations could result in serious
injury or death:
The ICC system is primarily intended
for use on straight, dry, open roads
with light traffic. It is not advisabl ...
Component diagnosis
DTC B2205 Vehicle speed circuit